Product description

3 layer chrome and plastic design for protecting the edge of your vehicle from scratching and shocking and adding a bit of style to its look, Great for interior and exterior decorating

the net door tall cover，decorative and pritective hood

Can be installed in four doors and door bottom and hood and trunk lid

The car door trim edge chrome U shape moulding trim strip protect the door from bumping, paint peeling，reduce noise，beautiful and practical

1 Four doors: Recommend 16 ft

1+2 Four doors and door bottom: Recommend 32 ft

1+2+3 Four doors and door bottom and hood: Recommend 48 ft

1+2+3+4 four doors and door bottom and hood and trunk lid: Recommend 64 ft

(For reference only, the specific required length is subject to measurement)

Product Description:

Color: Silver

Material: epoxy resin and chrome

Dimensions:64FT ( 16FT, 32FT, 64FT, please note the dimensions you want )

Fit:Fits most of Sedans, Trucks, SUV, ATV, UTV, Aluminum Boat door Edge trunk lids, hoods and grilles.NOT for those cars equipped with rubber strips or those car doors are too thick (such as T esla, VW Passat)

Installation process:

1. Clean the application area with rubbing alcohol or water.

2. Uncover the tape from the tip of the lining (Ensure the tape is install INSIDE the door) and peel the red strip off the tape by approximately 2 inches.

3.Start from the top, insert the lining onto your door edge until the lining is fully seated.

4.Press the lining with your thumb along the door edge until it is fully seated, then pull the red strip off.

5.The application can be cut and re-installed with scissors in a curved place.

6. Do not wash your car within 1~2 days after you installation

Note: If the tempeature is below 25 degree, please use a heat gun or blow dryer to heat it for 20 to 50 seconds, The trim will become softer, and more easier to apply on curve shape.